Cummins SPN 108 FMI 3: Meaning, Causes & Fix

Backprobe the sensor connector and measure reference voltage, signal, and ground. If the 5V reference is present and ground is good, but the signal is out of range, the sensor is likely bad. If reference voltage is missing or unstable, the problem is in the wiring or ECM. A wiggle test on the harness while monitoring live data will reveal intermittent connections.

It depends on the sensor. Non-critical sensors (barometric pressure, fuel temperature) typically trigger CHECK SOON codes and the engine runs on a default value. Critical sensors (accelerator pedal, crankshaft position) can cause stalling or no-start conditions. If the engine runs normally despite the code, you can usually drive to a repair facility, but do not ignore the code indefinitely.

CAN bus faults are caused by wiring damage (chafed or cut wires), corroded connectors, failed terminating resistors, or a faulty module that corrupts bus communication. Heavy-duty trucks use J1939 CAN which requires 120-ohm terminating resistors at each end of the bus. Measuring 60 ohms across CAN high and CAN low (with power off) confirms the bus is intact.

A new ECM for a heavy-duty diesel engine costs $1,500–$4,000 for the part alone, plus 3–6 hours of labor for installation, programming, and parameter setup. Remanufactured ECMs are available for $800–$2,000. Always verify the ECM is truly faulty before replacing — many ECM codes are caused by wiring or sensor issues, not the ECM itself.

Moisture ingress into sensor connectors causes corrosion and intermittent electrical contact. This is especially common at the engine harness pass-through connector (where wires enter the valve cover) and at under-hood sensor connectors that are not properly sealed. Dielectric grease on connector pins and OEM-rated weatherpack connectors help prevent moisture-related faults.

CHECK SOON codes are rarely false alarms. The ECM has detected a parameter outside normal operating range. Sensor malfunctions can sometimes trigger false readings, but the majority of CHECK SOON codes indicate a developing issue that will worsen if left unaddressed. Use a diagnostic scan tool to verify sensor readings before replacing expensive parts.

Basic visual inspection can be performed without a scan tool — check wiring harnesses for chafing, connectors for corrosion, and related components for physical damage. However, to verify the fault, view live sensor data, and confirm the repair, a heavy-duty diagnostic scan tool (or a compatible OBD-II adapter with J1939/J1708 support) is strongly recommended for accurate diagnosis.

Schedule service within the next 1–3 operating days. While the vehicle can continue operating normally, delaying repair increases the risk of the fault escalating to CHECK NEXT STOP severity. Additionally, some CHECK SOON conditions are precursors to emissions system faults that will trigger a mandatory derate if not addressed in a timely manner.