Generic SPN 4364 FMI 18: Meaning, Causes & Fix

Yes. EPA-mandated inducement systems require the ECM to progressively derate the engine if DEF-related faults are not resolved. First, the ECM limits vehicle speed to 55 mph, then 45 mph, and eventually 5 mph. The derate typically activates 50–200 miles after the fault is first detected, depending on the specific code and OEM programming.

If the DEF is contaminated with minerals, diesel, or water, simply adding fresh DEF will not fix the issue. The entire tank must be drained, flushed with deionized water, and refilled with fresh API-certified DEF. Running contaminated DEF through the dosing system can clog the injector and damage the SCR catalyst — a $3,000–$8,000 repair.

Using a scan tool, compare inlet and outlet NOx sensor readings at operating temperature. Under normal SCR operation, outlet NOx should be 70–90% lower than inlet. If both sensors read similar values, either the SCR is not dosing DEF or the outlet sensor has failed. You can also swap the inlet and outlet sensors — if the fault code moves to the other position, the sensor is bad.

Most OEMs recommend DEF filter replacement every 150,000–200,000 miles or at the first sign of crystallization. If you operate in extreme cold climates where DEF freezes and thaws frequently, inspect the filter every 100,000 miles. A clogged DEF filter causes low DEF pressure faults and can trigger a derate.

Removing or disabling the SCR system is a federal crime under the Clean Air Act and can result in fines up to $37,500 per violation. Many states perform roadside emissions testing, and deleted trucks fail DOT inspections. Additionally, SCR deletion voids the engine warranty and reduces resale value. Proper maintenance is far less expensive than the legal and financial consequences of tampering.

This CHECK AT NEXT STOP code allows continued operation to a safe service location, typically within 50–100 miles. Reduce engine load (avoid steep grades, reduce cruising speed) and monitor related gauges closely. If secondary symptoms develop — smoke, unusual noise, temperature spike — pull over immediately.

If addressed promptly at the next stop, permanent damage is unlikely. However, prolonged operation (200+ miles) with this fault active can escalate the issue. For example, DEF system faults will eventually trigger a full derate and speed limitation to 5 mph. Some CHECK NEXT STOP conditions degrade into STOP ENGINE faults if the root cause worsens — do not postpone service indefinitely.

You can attempt the diagnostic steps listed above. Many CHECK NEXT STOP codes have straightforward causes — low fluid levels, clogged filters, or loose connectors — that an owner-operator can address. However, if the code returns after clearing, the underlying fault requires professional diagnosis with a scan tool capable of viewing live data and freeze-frame information.