International SPN 111 FMI 18: Meaning, Causes & Fix

Symptoms include unexplained coolant loss with no visible external leak, white steam from the exhaust, rising oil level on the dipstick (coolant mixing with oil), and a sweet smell from the exhaust. A block test (combustion leak detector) will confirm exhaust gases in the coolant. EGR cooler failure is common on Cummins ISX15 and Detroit DD15 engines above 400,000 miles.

If the coolant level was simply low from normal consumption, topping off may resolve the code. However, if the coolant loss is due to a leak, the level will drop again quickly. Monitor the coolant level daily after topping off. If you lose more than 1 gallon in 1,000 miles, there is an active leak that must be found and repaired before it leads to overheating and engine damage.

Most modern heavy-duty diesel engines use Extended Life Coolant (ELC) meeting ASTM D6210 or CAT EC-1 specifications. Common brands include Fleetguard Compleat, CAT Extended Life, and Shell Rotella ELC. Never mix conventional (green) coolant with ELC — they are incompatible and can form gels that clog the radiator and EGR cooler. Always follow the OEM specification for your engine.

Yes, this is a classic symptom of a thermostat sticking closed and then snapping open. When the thermostat sticks, coolant stops circulating and temperature rises rapidly; when it finally opens, the temperature drops quickly. This cycling pattern will continue and gets worse over time. Replace the thermostat promptly — a fully stuck-closed thermostat causes rapid overheating and potential head gasket failure.

Replace coolant hoses every 4–5 years or 300,000–400,000 miles, whichever comes first, even if they look fine externally — internal deterioration is not visible. Replace the thermostat preventively at 300,000 miles. A preventive thermostat and hose replacement costs $200–$500, while a roadside overheating event from a failed thermostat can cause $5,000–$20,000 in engine damage.

No. This is a STOP ENGINE-level fault. Continued operation will cause severe engine damage including potential catastrophic failure. Pull over safely and diagnose before restarting. Tow the vehicle to a service facility if the root cause cannot be identified and resolved at roadside.

1) Pull over at the first safe location — use hazard lights and reflective triangles if on a highway shoulder. 2) Shut down engine. 3) Check for obvious issues: fluid leaks, smoke, loose connections, unusual odors. 4) Scan for secondary fault codes using a dash display or diagnostic tool — these often point to the root cause. 5) Call roadside assistance if unable to resolve. Do not attempt to limp the vehicle to a shop.

Ignoring a STOP ENGINE code can result in: turbocharger failure ($3,000–$8,000), engine seizure requiring complete overhaul ($15,000–$40,000), or fire risk from leaking fuel/oil contacting hot exhaust components. If this code is accompanied by low oil pressure or high coolant temperature, engine failure may occur within minutes of continued operation.